Our living room throw pillows needed an upgrade. At $20-30 a pop, I wasn't about to buy two new ones, so I dug through my fabric stash and found an old lace curtain panel. Two cuts and four seams later I had a couple of gorgeous throw pillows.
Here's how.
Materials:
1 lace curtain panel
2 square pillow forms
straight pins
sewing machine
Directions. Lay out your curtain panel on the floor and place your pillow on top of it to measure how much fabric to cut. If you have a removable slip cover on the pillow already, then remove it and use the cover as a guide. Cut the curtain widthwise, leaving a half an inch of seam allowance on the top and bottom edge.
I made an envelope slip cover, but instead of the envelope being on the back side, like most throw pillows, it is on the front because the lace trim is already a finished edge and it looks so pretty overlapped.
Lay your pillow on the long width of fabric and figure out how you want it to overlap. Fold one edge over the pillow and the other edge over. Mark where you folded and remove the pillow. Refold the lace and pin the raw edges in place.
Sew across both edges. Turn right side out and stuff your pillow inside. That's it! Repeat with second pillow.
Questions? Leave me a comment!
No comments:
Post a Comment